A Set of 3 Integrated 0XA Tool Holders for use with DCGT-21.5x, DCMT-21.5x or DCGT-21.5x Carbide Inserts. 0XSDJCR – Right Handed Tool. The cutting edge of this tool holder is on the left side when viewed from above. Used for right to left turning, meaning that material is removed as the cutting edge moves towards the lathe chuck. This tool orientation is the most common for turning operations. Used for reducing the diameter of a workpiece and for facing the right end of the workpiece. Approach Angle 93°, (Front Angle 87°, Back Angle 32°). Shank Length 1.1″ (27.5mm), Shank Dimension 0.67″ (17mm h) x 0.5 (12.7mm w). 0XSDNCN – Neutral Tool. The cutting edge of this tool holder is centered on the tool holder shank when viewed from above. Used for left to right as well as right to left turning. Limited usefulness for facing, i. Neutral handed lathe tools are used in applications where the machining setup requires cutting in both directions (fine finishing) and can be used to create. Beveled edges in areas where the front and back angles of the neutral tool is less than the beveled angle desired. Approach Angle 62.5°, (Front Angle 117.5°, Back Angle 62.5°). Shank Length 1.1″ (27.5mm), Shank Dimension 0.67″ (17mm h) x 0.26 (6.7mm w). 0XSDJCL – Left Handed Tool. The cutting edge of this tool holder is on the right side when viewed from above. Used for left to right turning, meaning that material is removed as the cutting edge moves away from the lathe chuck. Left handed lathe tools are used in applications where the machining setup requires cutting in the opposite direction of right-handed tools and can be used to create beveled edges in areas where the back angle of neutral and right-handed tools is less than the beveled angle desired. Approach Angle 93°, (Front Angle 148°, Back Angle 93°). For use with 0XA series mini tool posts only. Will not fit AXA or BXA Tool Posts. Interchangeable with Dorian, Aloris, Yuasa & Phase II. Alloy Steel with Mil-C-13924 Black Oxide Finish. Use with DCMT-21.5x, DCGT-21.5x and DCGX-21.5x 55°. Car bide Inserts I. 0.25 – 6.35mm. Overall Dimension of each Holder: 3.2″ x 0.8″ x 2 (80mm x 20mm x 50mm). No time wasted with shims. No tool post indexing necessary. No need to disturb basic setup. Kit complete with three integrated 0XA Holders (one each Left, Right and Neutral) with Height Stops, (1) T8 Flag Handle Wrench, (3) M2.5 Screws and (3) DCMT-21.51 Inserts.