As pictured vintage watchmaker/tool-room Pultra lathe, model-P, the bed is 16 long, 10mm twin support headstock, 50 mm centre height. This Model P bed will accept two headstocks the 8 mm collet PH2(not included) and the 10 mm collet PH4. The headstocks were fitted with split bronze bearings were designed for continuous running at 10,000 rpm. The bearings were intended to run “warm” at all speeds. The paint (“War Finish”) 95% intact. The lathe is in very good clean working condition, comes as pictured with 90 volt DC motor and control. The tailstock has the lever and accept 8mm WW collets. The machine has enough power to turn a steel pivots. All parts in a good shape (no excessive play parts). The unit tested and it seems to turn smoothly and accurate. Screw-feed compound slide rest. 16 long bed with 50mm center height. Headstock spindle rotates smoothly with no end shake. Lathe has all it’s levers, dust covers, drawbar and tailstock knob. No chips or nicks on the pulleys. Collet index pin inside spindle is good. Headstock take 10mm collets, you can use 8mm collets with adapter(not included). Alignment between headstock and tailstock is good. The chuck is new. So, please carefully review all the attached pictures, ask all the questions you have, prior to deciding to acquire it. Thank you for stopping by. The item “WATCHMAKER TOOL-ROOM PULTRA LATHE MODEL-P 16 BED 10MM HEADSTOCK” is in sale since Friday, October 15, 2021. This item is in the category “Jewelry & Watches\Watches, Parts & Accessories\Parts, Tools & Guides\Tools & Repair Kits”. The seller is “pilot-rf” and is located in Boca Raton, Florida. This item can be shipped to United States.
- Brand: Pultra
- Model: P
- Country/Region of Manufacture: United Kingdom
- Type of Tool: Lathe
