October 3, 2016
This Atlas Lathe is a model QC54 which will swing 6″ over the carriage or 10″ over the ways with 36 between centers. It has 8 speeds in belt drive and 8 speeds in back gears. It has a quick change gear box. It has seen little use and the ways show no wear. Everything […]
September 30, 2016
South bend 9 inch lathe with tooling and everything in the photos. Has a 6 inch 4 jaw chuck. The motor is a 1/6 hp. Motor and forward reverse controller work well. Also has two belts. All the wrenches for the lathe are with it and some tooling. Set of Treading gears. This lathe is […]
September 8, 2016
Hi folks here is a nice bench top southbend lathe , it came from a shop that was using it to make small wood and plastic. Parts , it runs strong with minimal play , it is 110 volt with forward and reverse , the model number is C L 644 A. It has a […]
August 14, 2016
Jewelers Lathe Tooling Set in Wood Block Vintage Wolf Jahn & Co. Looks to be in good condition. The “brush” attachment looks worn, but everything else looks good as far as I can tell. Doesn’t appear that there is anything missing, but I can’t be sure. From the estate of a jeweler/watchmaker who used it […]
August 4, 2016
This tooling has a 14 millimeter diameter shank, and I have seen these tailstocks bored out to take standard 5? 8 Brown & Sharpe tooling, as well as bushings made to use the 1/2 inch Levin turret tooling as well. But if you want the proper original tooling to use in your turret, here is […]
July 23, 2016
Nice old south bend 9 engine lathe with back gear. Complete with change gears and a good bit of tooling. Also includes the bench it is mounted on and the old chest full of stuff. This lathe is in nice shape and is very usable. If you’re in my area, take advantage of this LOW […]
July 12, 2016
FINE USED ATLAS 10100 6 INCH SWING LATHE. ALL ORIGINAL AND RUNS ON 110V. I CAN ADD TOOLING AS REQUIRED FOR ADDITIONAL COST. SHIPS HEAVY AT 110 POUNDS. The item “FINE USED ATLAS 10100 6 INCH LATHE COMPLETE LESS TOOLING 110V CLEAN” is in sale since Friday, July 08, 2016. This item is in the […]
July 3, 2016
Clausing 12″ x 36″ Lathe With Tooling. Nice working example of a 5914 Clausing. This has been my main gunsmithing lathe for about 10 years. Everything on it works: all quick change gears, high-low, clutches, back gear, and the hydraulic variable speed. All feeds and all speeds work. Since I have owned this machine I […]
June 30, 2016
June 11, 2016